Cover Site Prep & Utilities: The Las Vegas Owner’s Guide
Ellery ADU Studio installs Cover-compatible site prep and utility packages in Las Vegas, and an all-in utility and site work scope for a Cover unit typically runs $18,000 – $42,000 depending on trench length, panel capacity, and how much grading your lot needs. We are an independent design-build studio, not affiliated with Cover, and we quote every package at a written price before work starts. Homeowners usually discover a problem the same way: the Cover unit is scheduled, the crane date is set, and the electrician walks the lot and finds the service panel has no room for a 100-amp subfeed, or the sewer invert is three inches too shallow for gravity flow. In Las Vegas, that discovery lands in the middle of summer, when the trench is being dug into caliche that hasn’t seen water since April.
Key Takeaways
- Cover units arrive ready for utilities; the site work around them is where budgets move.
- Most Las Vegas lots need caliche excavation, which changes trench cost.
- A written scope and written price come before any digging, always.
- Our technicians have up to 11 years of experience reading Nevada soil and utility records.
Which Cover Models This Applies To

Cover’s product line spans one-bedroom studios through two-bedroom configurations, and the utility package changes with each footprint. A studio typically needs a single 100-amp subfeed, one sewer lateral, and one water line; a two-bedroom pushes to 125 or 150 amps because of the dryer and range, and that changes the panel work dramatically. To confirm what you’re looking at, check the data plate on the unit’s electrical panel, not the marketing brochure. The plate lists the service amperage, and the model designation is stamped on the structural frame near the utility chase.
For Cover specifically, the compatibility question is rarely the part and almost always the interface. Cover’s factory-set utility stub locations are fixed, so site prep has to be built to meet those stub points exactly. When we specify a package, we work from Cover’s published stub-out dimensions and confirm them against the delivered unit’s photo record before we trench. Aftermarket equivalents are fine for conduit, fittings, and panel hardware; they are not fine for the disconnect and feeder terminations, where we use listed components rated for the unit’s amperage and inspectable under Clark County code.
Signs Your Cover Site Prep & Utilities Is Failing
- Breakers trip when the dryer and AC run together. The panel was sized for the unit as delivered, not as installed, and the load calculation missed the Las Vegas cooling load. A 100-amp service running a heat pump in July is close to its ceiling.
- Slow drains after monsoon season. The sewer lateral was bedded in native soil that shifts with moisture. Las Vegas gets roughly 4 inches of rain a year, most of it in short bursts, and that shock moves poorly bedded pipe.
- Standing water against the unit’s base. Grading wasn’t sloped away from the foundation. On a lot with caliche hardpan, water sits because it can’t percolate. That’s a site prep failure, not a Cover unit failure.
- Conduit exposed or heaved out of the trench. Trench depth was short of the 18-inch minimum for PVC feeder conduit and the soil lifted it. This is common in newer Las Vegas subdivisions built on fill.
- Water pressure drops when the ADU and main house run at once. The water line was sized for the ADU alone. Las Vegas water pressure runs high at the meter, so the symptom often shows up as a banging noise rather than low flow.
Replacement Cost & What’s Included

Site prep and utility packages for a Cover unit in Las Vegas break down roughly like this:
- Electrical service upgrade and subfeed: $6,000 – $14,000, driven by panel capacity and trench length.
- Sewer lateral and water line: $7,000 – $16,000, driven by distance to the connection point and caliche excavation.
- Grading, drainage, and pad prep: $3,000 – $8,000, driven by slope and how much rock we hit.
- Permits and inspection coordination: $1,500 – $4,000 in Clark County fees and review time.
Every one of those line items is locked at signing under Haven Standard Clause 1, which means no change orders unless you approve a written revision. The work carries a documented photo record on every visit, and the 365-Day Done Right Promise backs the installation in writing. A Free Second Opinion is available on any written estimate you already have in hand.
DIY or Call Us?
You can safely read your own panel label, measure the distance from the unit’s stub points to your property line, and pull your lot’s utility records from the Clark County assessor. What you should not do yourself is trench into a buried gas or electrical line, terminate a feeder at a disconnect, or open a sewer lateral. Las Vegas lots carry unmarked irrigation lines and, in older neighborhoods, undocumented service runs. Cutting into one of those is a genuine injury and property risk, and the repair cost dwarfs what an electrician charges for an afternoon. Our technicians have up to 11 years of experience and we coordinate the trade inspections under the same contract. Call (866) 779-3194 to schedule a walkthrough and a written price.
FAQs

How long do Cover site prep and utility installations last in Las Vegas? A properly installed package should last 30 to 40 years for the buried lines and trench work, with the electrical panel typically the first component to need attention at 20 to 25 years. The Las Vegas climate is actually kind to buried PVC, but the caliche soil and monsoon runoff are hard on bedding and grading.
Can a failing utility package be repaired instead of replaced? Often yes. A short sewer lateral can be re-bedded, and a panel upgrade can sometimes be solved with a subpanel rather than a full service replacement. We diagnose first and quote the repair alongside the replacement, so you see both numbers in writing before you decide.
How long does the installation take? A standard Cover utility package in Las Vegas takes 3 to 6 weeks, with the trench and rough-in portion often finishing in under two weeks. Clark County inspection scheduling is the variable we can’t compress, so we build that time into the written schedule rather than around it.
How do you source the parts? We work from Cover’s published specifications and confirm the component list against the unit’s data plate before ordering. We hold no parts inventory and carry none on a truck, which means nothing gets installed because it happened to be on hand. Every component is ordered to the unit’s actual amperage and stub configuration.
Call (866) 779-3194 to schedule your free estimate. We’ll walk the lot, read the panel, and put a written price in front of you before any digging starts.
Written by the team at Ellery ADU Studio Las Vegas, serving Las Vegas and nearby areas.












