Cover Garage Conversion ADU: The Las Vegas Owner’s Guide
A Cover garage conversion ADU in Las Vegas typically runs $118,000 – $186,000 all-in, drawings through final inspection, and the structural and enclosure scope is where most of that money sits. When something in that envelope fails – a header connection, a panel seam, a waterproofing lap – you don’t get a dramatic collapse. You get a hairline crack above the garage door opening, a soft spot in the drywall near the slab, or a ceiling stain that shows up after the first monsoon week in July.
Owners usually discover the problem the same way: they’re storing boxes in the new unit, they run a hand along the wall, and the wall gives. Or the door stops latching square because the opening has moved a quarter inch. By the time a symptom is visible on a Cover conversion, the underlying cause has typically been working for a season or two.
Which Cover Models This Applies To

Cover builds its garage conversions around a panelized wall and roof system with a proprietary connection detail at the existing garage opening – the moment you convert a garage, that opening becomes the weakest plane in the structure, and Cover handles it with a specific header-and-post assembly rather than a generic beam. That assembly is what most of the repair work on a Las Vegas Cover conversion touches. We are an independent design-build studio, not affiliated with Cover, and we specify and coordinate their systems under our own single contract.
Identifying the right component starts with the permit set Cover produced for your unit, not with the part in your hand. Look for the stamped drawing sheet showing the opening elevation and the panel schedule; the schedule lists the panel series, and the series determines the connection hardware. Measure the opening width and height to the nearest eighth inch and compare against the schedule before ordering anything. On the OEM-versus-aftermarket question, Cover-specific connection hardware is worth sourcing OEM – the tolerances are tight and a hardware-store substitute will fit but won’t carry the load path the drawing assumes. Finishes, trim, flashing, and sealants can be matched to quality equivalents without the same risk.
Signs Your Cover Garage Conversion ADU Is Failing
- A diagonal crack radiating from the corner of the old garage door opening. That corner concentrates stress, and a crack there usually means the header connection has lost bearing or the post base has settled. In Las Vegas, caliche-heavy soils and summer shrink-swell cycles make this the first place a conversion shows movement.
- A door that no longer latches square. When an interior door drifts out of plumb, the frame has racked. It’s a symptom of movement at the opening, not a hinge problem, and adjusting the hinge will only hide it for a season.
- Soft drywall or efflorescence near the slab line. White powdery staining at the base of a wall means moisture is wicking through the slab edge. Garage slabs aren’t vapor-sealed the way living space requires, and a conversion that skipped a capillary break will show it here.
- Ceiling or wall stains after a rain event. Cover’s roof-to-wall transition relies on a lapped flashing detail. A failed lap lets water in behind the panel, and you’ll see the stain on the interior before you see the gap on the exterior.
- Gaps opening at panel seams. Visible separation between panels points to movement in the connection hardware or fastener back-out. On Las Vegas conversions with west-facing walls, thermal cycling from 110-degree afternoons to 70-degree nights works fasteners harder than in milder climates.
Replacement Cost & What’s Included

Repair and replacement on the structural and enclosure scope of a Cover conversion in Las Vegas runs roughly $2,400 – $9,800 depending on what’s actually moving. A header connection rebuild with new hardware, post base work, and drywall repair sits near the low end. Opening up a wall, correcting a settled post, re-flashing the roof-to-wall transition, and refinishing lands near the high end. Waterproofing and flashing repairs alone typically run $850 – $2,600.
The parts-plus-labor split is written on your estimate, line by line – we don’t bundle hardware into a labor figure to make the number look smaller. Under The Haven Standard, you get a written price before any work starts, and the scope is locked at signing. Workmanship carries a 365-Day Done Right Promise in writing: if it isn’t built to the permitted drawings, we make it right.
DIY or Call Us?
You can safely check a few things. Run a level against the door frame. Photograph any crack with a ruler in frame so you can measure movement over a month. Look at the exterior flashing where the roof meets the wall and note any visible gap. Write down the date of the first stain. That documentation is genuinely useful, and we’ll read it.
What you shouldn’t do is open the wall, cut into the header assembly, or try to re-flash the roof-to-wall transition yourself. The header on a converted garage opening carries the load of the wall above it, and cutting into it without knowing the load path is the kind of mistake that shows up six months later as a sagging ceiling. This is structural work, and it belongs with people who can read the permit set. Our technicians have up to 11 years of experience with these systems. Call (866) 779-3194 and we’ll tell you what we’d check first.
FAQs

The structural and enclosure scope should hold 30 to 50 years when the flashing and waterproofing details are maintained. The variables that shorten that in Las Vegas are thermal cycling on west-facing walls and the lack of a vapor break under an unsealed garage slab. Inspect the roof-to-wall transition annually, ideally before monsoon season in July.
Often yes, if the movement is caught early and the post base hasn’t settled. A hardware-only repair with new fasteners and re-torqued connections can run a fraction of a full rebuild. Once the post has settled or the header has lost bearing, replacement is the honest answer, and we’ll show you the photo record of what we found so you can see the difference yourself.
A hardware repair on accessible connections is typically a one-day job with drywall patching the following day. A header rebuild with opening work runs three to five working days because of the inspection sequence: framing inspection, then close-up, then finish. Las Vegas permitting on a structural repair to an existing conversion usually adds a short review cycle before we start.
We work from your permit set and panel schedule, then order against the series listed there rather than guessing from a photo. That’s how we avoid the most common compatibility mistake on these units: ordering hardware for a neighboring series that looks identical but has a different connection detail. If you already have a written estimate from another contractor, we’ll give you a free second opinion on it before you commit to anything.
If your Cover garage conversion in Las Vegas is showing cracks, stains, or a door that won’t latch square, call (866) 779-3194 for a free estimate. We’ll bring the written price, the photo record, and a straight answer about whether it’s a repair or a rebuild – and the 365-Day Done Right Promise backs the work either way.
Written by the team at Ellery ADU Studio Las Vegas, serving Las Vegas and nearby areas.












